GARMIN SL30 MANUAL PDF

Also for: Apollo sl30 nav, Apollo sl All rights reserved. Dual Antennas. GS Antenna. Printed in the USA No part of this document may be transmitted, reproduced, or copied.

Author:Kagul Dourr
Country:Panama
Language:English (Spanish)
Genre:Business
Published (Last):17 July 2018
Pages:334
PDF File Size:5.27 Mb
ePub File Size:1.31 Mb
ISBN:743-9-54880-246-2
Downloads:94154
Price:Free* [*Free Regsitration Required]
Uploader:Jumuro



Quick Links. Download this manual See also: Quick Reference Manual. Table of Contents. Page 2 No part of this document may be transmitted, reproduced, or copied in any form or by any means without the prior written consent of Garmin AT, Inc. It is the responsibility of those desiring to install this article on or within a specific type or class of aircraft to determine that the aircraft operating conditions are within TSO standards.

Page 4 OTES Page 6 Table of Contents Page It is intended for use by persons certified by the Federal Aviation Administration FAA to install aircraft navigation devices. This includes with or without an external course deviation indicator.

The CDI may be discrete, serial, or composite. The standard items included in the package are listed in Table 1. External devices required for various installations are listed below.

A post installation check-out procedure is included at the end of this section. Page Mounting Installation 3. Page Pacing dimples help maintain the proper clearance. The mounting tube must be installed with the clearance dimples pointing up.

The mounting tube should be flush to the instrument panel and allow sufficient clearance for the back of the bezel of the unit to mount flush to the mounting tube. Sufficient clearance must exist in the instrument panel opening to allow ease of insertion and removal of the unit. The front lobe of the cam should be vertical. The cam lock mechanism should be fully unscrewed turned counter-clockwise.

Slide the unit into the frame. Turn clockwise and carefully hand-tighten 4 in-lb max. The crimp contacts are specified for 20 to 24 awg wire. Make the crimp connections with a crimp tool as specified on page 6. All wires should be 20 to 24 AWG unless otherwise specified. Wiring diagrams are included in this section. Attach the signal ground to the mic ground pin on the rear connector and connect the shield to the rear connector plate.

Step 3. Its size dictates room for only one Comm antenna input and one NAV antenna input. This unit has been fully environmentally qualified for use with single and dual SL30 installations. Nav Audio may be left floating at the SL NOTES: 2. Avionics power leads should use 20 awg wire. All others are specified at awg. Use shieled cable for resolver signals 2.

Use shieled cable for Resolver signals 2. Connect shield grounds to aircraft chassis with as short a conductor as practical. Refer to Limitations on Using Composite Signal paragraph in this chapter.

Use shieled cable for resolver signals. Connect shields chassis ground at both ends of each shielded cable. Press each button. The function name for each control will appear on the display after the button is pressed.

Page 44 Installation 3. Rotate the small knob to change the value. The values "" may be used to center the GSI needle. Turn the small knob left or right to center the needle. Press ENT when the needle is centered. Page Final System Check Enable weather frequencies This function determines whether the weather frequencies in common use in North America are displayed, or not.

In the Setup Mode, rotate the large knob to select E 2. Press SEL to activate selection. The Yes or No value will flash. Page F Eatures Installation 4. Verify that the remote frequencies of the airport selected via the GPS unit are displayed on the SL Maintenance manual information system description, operation, location, removal, testing, etc.

Note: Performance specifications are measured at ambient temperatures unless otherwise noted. At least 60 dB down Receiver sensitivity Page Glideslope Specifications Audio response Page Comm Receiver Performance Output signal voltage D Frequency range Page Intercom Performance Specifications Stuck mic time-out Two inputs, standard carbon or dynamic mic with Headphone audio output level Input pulled low to ground to enable the transmitter The pinout for the connectors is listed in the following tables.

Use Table 4 to assist in troubleshooting. Problem The SL30 does not power on. Garmin AT, Inc. SE Salem, Oregon Phone Page Appendix B - Periodic Maintenance The oscillator frequency can be checked by connecting the transmitter output through an appropriate load to a calibrated frequency counter. The transmit frequency should be within 15ppm of the selected channel frequency. Contact the Garmin AT factory for instructions on adjusting the frequency if required.

Mini-Circuits Manufacturer Part Refer to page The interface format conforms to NMEA message format specifications. The SL30 will be able to accept all messages intended for an SL40 without generating a serial communications error.

Message Class. This is a COMM message. Message Identifier. Apollo SL30 Installation Manual VOR station identifier. Note that if the station identifier is less than four characters, then the trailing characters will be filled with spaces. Airport identifier. Note that if the airport identifier is less than four characters, then the trailing characters will be filled with spaces.

Message class. Message identifier. Message data, two encoded hex output request. After power up this message will be output at a 10 Hz rate. After power up this message will be sent at a 10 Hz rate. Page Decoded Station Identifier v Valid flag. It will be output upon request or whenever the status changes. This manual is also suitable for: Apollo sl30 nav Apollo sl Print page 1 Print document 88 pages.

Cancel Delete. Sign In OR. Don't have an account? Sign up! Restore password. Upload from disk.

ENFERMEDAD DE DEJERINE SOTTAS PDF

Garmin sl30 installation manual

Quick Links. Download this manual See also: Quick Reference Manual. Table of Contents. Page 2 No part of this document may be transmitted, reproduced, or copied in any form or by any means without the prior written consent of Garmin AT, Inc. It is the responsibility of those desiring to install this article on or within a specific type or class of aircraft to determine that the aircraft operating conditions are within TSO standards.

BADINAGE BOZZA PDF

Garmin apollo sl30 comm User Manual

All rights reserved. Printed in the USA No part of this document may be transmitted, reproduced, or copied in any form or by any means without the prior written consent of Garmin AT, Inc. Garmin AT, Inc. Added interface wiring diagrams, refined post installation checkout procedures. SW Version 1. Changed logo and added JTSO information.

AVATAMSAKA SUTRA THOMAS CLEARY PDF

Garmin Apollo SL30 COMM Installation Manual

.

Related Articles